Necklace and earrings with honey calcite and freshwater pearls

Necklace Measure a piece of chain to match the length you want your necklace to be (subtract the length of the beads). Attach the large yellow crystal and a freshwater pearl to an eye pin and then attach the first piece of chain.

2 Turn the end at least one and a half turns at a distance of 2 mm from the bead.

3 Cut off the excess eye pin using a cutting nipper.

4 Open the eyelet on the eye pin and attach the chain. Now close the eye pin.

5 Now, cut the chain over where you want the next bead to sit, attach the bead and chain to an eye pin and turn the end at least one and a half turns at a distance of 2 mm from the bead, as shown in the picture.

6 Cut off the excess from the eye pin.

7 Open the eyelet on the eye pin and attach the last piece of chain. Now close the eye pin. Repeat this process until all the desired beads have been added.

8 Now take an round jump ring and open it by twisting it apart as shown in the picture.

9 Guide the round jump ring through the outermost chain link.

10 Now attach the carabiner clasp to the round jump ring and close the ring by twisting it back into place. Repeat the process on the side without the carabiner.

Earrings Place the desired beads on a head pin. When this is done, attach the earring with chain.

12 Now, turn the end at least one and a half turns at a distance of 2 mm from the bead, as shown in the picture.

13 Cut off the excess from the head pin and the earring is ready to wear.