Several Bracelets in One – assembled in Fold-Over End Caps

1.   A twisted bracelet: Wrap the macramé cords around the LoopDeDoo device and keep the looping cord tight with one hand (holding the hand close to the bracelet). Turn the handle with the other hand.

2.   A braided bracelet with rhinestones: Attach a doubled-over piece of macramé cord onto the hooks. Place the rhinestone jewellery chain on top and secure it with a piece of yellow macramé cord. NB: Braid a couple of knots after each rhinestone. See idea number 12499 for further instructions.

3.   A plaited bracelet: attach three doubled-over pieces of macramé cord onto the LoopDeDoo device and plait to a desired length. NB: make sure that the cords lie flat whilst plaiting.

A Bracelet woven on a Bead Loom   Thread the beam loom following the enclosed instructions. Use a beading needle and rocaille seed beads when weaving. You may draw the pattern on a piece of graph paper beforehand. See idea number 12858 for further instructions.

A Bracelet with Clay Beads   Thread Indian beads onto a piece of elastic beading cord using a beading needle.

Assemble all the bracelets into one bracelet   Trim all the ends and secure with glue.

1.   Gather all the different individual bracelets and keep them in place securely with a piece of masking tape.

2.   Apply glue on both inner sides of a fold-over end cap. Place each end of the assembled bracelets inside the fold-over end cap (with one end cap at either end of the bracelet).

3.   Use flat nose pliers and carefully squeeze the fold-over end caps together. Let them dry for three to four hours.

4.   Attach an oval ring at one end of the fold-over end cap. Attach an oval ring with a lobster claw clasp at the other end of the bracelet.